header
Back to home page Back to Praxair Corporate Site Welding Supplies Specialty Gases and Equipment Back to Cart Praxair Direct Price Quote Button Sign in Register Contact Us Store Locator Home Resource Center

For questions about Praxair products
please call 1-800-PRAXAIR or email us.

Plasma Arc Gouging (PAG)

 

 

Plasma arc gouging (PAG) is an adaptation of the plasma cutting process where arc constriction is reduced, resulting in a lower arc stream velocity. The temperature of the arc and the velocity of the gas stream melt and expel metal in a similar manner to other gouging processes. Compared to carbon arc gouging, plasma arc gouging produces a bright, clean gouge, particularly on stainless steel and nonferrous materials such as aluminum. Almost no post-cleaning is required prior to welding the plasma-gouged surface. Mixtures of argon with hydrogen are typically used as a plasma gas for gouging operations. The secondary or cooling gas, when used, is typically argon or nitrogen.

The technique for plasma arc gouging is essentially the same as for other gouging methods. The torch is angled approximately 30 degrees from the horizontal, and gouge depth is determined by speed of travel, torch angle and velocity of the plasma jet. It is important not to remove too much metal in a single pass. Plasma arc gouging is most effectively performed with power supplies that produce 200 amps or more.

Why Plasma Arc Gouging?

Limitations